Arduino
Espressif System (ESP)
Raspberry Pi
LED
TVS
Microphones
FLAME DETECTOR SENSOR MODULE
99.00৳
The Flame Sensor Module can detect flames in the 760 – 1100 nanometer wavelength range. Small flames like a lighter flame can be detected at roughly 0.8m. The detection angle is roughly 60 degrees and the sensor is particularly sensitive to the flame spectrum.
Out of stock
An on-board LM393 op-amp is used as a comparator to adjust the sensitivity level. The sensor has a digital and analog output and sensitivity can be adjusted via the blue potentiometer.
This Flame Sensor Module is used to detect fire/flame source or other light sources of the wavelength in the range of 760nm – 1100 nm. It is based on the YG1006 sensor which is a high speed and high sensitive NPN silicon phototransistor. Due to its black epoxy, the sensor is sensitive to infrared radiation.
The sensor can be a great addition in a firefighting robot, it can be used as a robot eyes to find the fire source. When the sensor detects flame the Signal LED will light up and the D0 pin goes LOW.
The module has 2 outputs: Analogue, which gives a real-time voltage output signal on thermal resistance, and digital which allows temperature thresholds to be set via a potentiometer.
Specifications:
High sensitivity IR receiver
Extremely sensitive to wave between 760-1100nm
Power supply indicator lamp
Comparator output indicator lamp
AO, real-time thermister voltage signal output
DO, high / low electric level signal output
Analog quantity output
Threshold rollover electric level output
Threshold adjusted by potentiometer
Detection Angle Range: About 60 degrees
Power Supply: 0-15 V DC
Hole Inner Diameter: Approx. 3mm
Size (L x W): Approx. 36 x 16mm
| Brand |
– |
|---|---|
| MFR# |
– |
| Package/Size |
– |
| Connectivity |
– |
| IO Ports |
– |
| EasyEDA ID |
– |
| Mounting |
– |
You must be logged in to post a review.
Related products
Reviews
There are no reviews yet.